Blog
Home

Blog

How to Clear &Disinfect Your Two-way Radios?

How to Clear &Disinfect Your Two-way Radios?

  • October 23,2020.

General Cleaning of your radio

*Removing heavy dust, soil, mud, grime, stains, etc.

*Prepare a solution of a non-abrasive dish detergent and water, with no more than 0.5% detergent in the solution. Some manufacturers recommend using distilled water.

*Apply the solution to the surface of the radio with a soft, non-abrasive cloth. Note: do not apply any liquid directly to the surface of the radio. Apply it to the cloth first, then to the radio from the cloth.

*Use a stiff, non-metallic and short bristled brush to loosen and remove the dirt from the surface and crevices of the radio.

*Wipe the debris and moisture from the radio with a dry, soft, lintless, absorbent cloth.

*Be sure to remove all moisture from the radio, including any metallic contacts, connector ports, cracks and crevices.

*Allow the radio to fully dry before attempting to install the battery(ies), charge or use the device.


Disinfect your two way radio

* Wipe down the radio using isopropyl alcohol with a 70%-80% concentration. Below 70% will not be effective.

*Apply the isopropyl alcohol to the surface of the radio with a soft, non-abrasive cloth first, then to the radio from the cloth. Do not apply it directly to the radio.

*Be sure wipe down into the cracks and crevices in the radio to effectively disinfect from germs.

*Some manufacturers allow the use of an antibacterial wipe, but excess liquid must be squeezed out of the wipe before use so that it is merely damp, not wet, to avoid over saturating the radio with fluid.

*Be sure to remove all moisture from the radio, including any metallic contacts, connector ports, cracks and crevices.

*Allow the radio to fully dry before attempting to install the battery(ies), charge or use the device.


*Be sure the radio is turned off.

*Remove the batteries or battery pack before cleaning.

*Clean a battery pack housing separately, and only the outer facing plastic shell or housing.

*Remove the belt clip if possible and clean it separately.

*Remove any externally connected accessories such as earpieces, headsets or hand microphones before cleaning.

*Clean your radios in a well ventilated area and away from heat sources.




YANTON specializes in the manufacture and supply of network radio, two-way radio systems, etc. We provide wireless communication equipment with OEM&ODM services. Here you can find the products you want, if you are interested in our radio, you can contact us.


© Copyright: 2024 QUANZHOU YANTON ELECTRONICS CO., LTD. All Rights Reserved.

IPv6 network supported

top

Leave a message

Leave a message

    If you have questions or suggestions,please leave us a message,we will reply you as soon as we can!